9516_ii_140613 Pg 1
9516
Rough for Floor Mount Tub Filler
(for use with 1103-XX, 1203-XX, 1303-XX & 1403-XX)
Installation Instructions
3
5
IMPORTANT: Read all instructions prior to installation and provide copy of instructions to consumer.
Operating Specifications:
Recommended Supply Pressure: 20 to 70 psi
*†
Maximum Flow Rate: 15 gpm
* Operating pressures between hot and cold supplies should vary no more than 30 psi.
† If water pressure exceeds 70 psi, install a Pressure-Reducing Valve (RPV).
PREPARING SUPPLY NIPPLES
• Remove MUDGUARDS❶
• Using 3/8” hex KEY❷(not supplied), remove ½”
PLUGS❸ from NIPPLES❺
Important: It is the responsibility of the INSTALLER to refer to
the various installation methods shown in steps or to
determine proper rigid copper PIPES❿ lengths.
• Solder or use female adapter to attach rigid copper
PIPES❿ to bottom inlet of NIPPLES❺
WATER TIGHT SEAL
• Apply Teflon
®
TAPE❹ (not supplied) onto
PLUGS❸
• Using 3/8” hex KEY❷ (not supplied), secure ½”
PLUGS❸ (MAXheight3/8”)into NIPPLES❺
Important: Tighten PLUGS❸,3/8” MAX height into NIPPLES❺
so that PLUG❸ does not interfere with MUDGUARD❶
Only supplied PLUGS❸ may be used to ensure proper fit and
installation height of MUDGUARDS❶
• Place MUDGUARDS❶ onto NIPPLES❺
CALIFORNIA FAUCETS RECOMMENDS THAT ALL PLUMBING PRODUCTS BE INSTALLED
BY A LICENSED PROFESSIONAL
Use Rigid
Copper Pipe
3/8” MAX
Commentaires sur ces manuels